To improve and perfect the comfort and fit of your skates, every skate comes with a heat mouldable MY Fit liner. The heat mouldable foam in the liner can be adjusted to your personal foot shape, forming the liner so it fits like a second skin.
To heat mould your MY Fit liner, simply remove the liner from the skate and take out the innersole.
Put the Power Heater inside the liner (not too deep, so it still gets air and will not overheat). Put the Power Heater on full temperature and full speed and it should take around 5 to 7 min to warm up one liner.
Put the liner into an oven at 80-90° for around 5 to 7 min.
Put the innersole again into the liner and place your feet inside the warm liner, put the heat moulding sock or any normal sock over the liner...
...and put it back into the skate.
Lace them up as tight as possible. Make sure to use all parts of the closure system: straps, the buckle, the Atop clap snap wrap 360° closing system or the lacing.
Keep seated while having your knees positioned over the toes during the cooling periode.The result will be a perfectly fitting liner and an extremely comfortable skating experience.
If needed this process may be repeated, as often as you want.