Preparation of the foot for the heatmoulding of the MY FIT thermo liner: Place the rubber toe cap on the customers foot. If needed add on some foam materials to pressure sensitive points like ankle, tendon and front foot.
Pre-heat the oven at 70°-80°C (80°-90°C for the Star Liner), take the innersole out of the MY FIT thermo liner and put it in the centre of the oven - ATTENTION: make sure there is some distance between the liner and the oven walls and/or the heating source.
Leave the MY FIT thermo liners 5-7minutes inside the oven and then take them out. On the picture you can see the liner after it was taken out of the oven, it´s deformed completely.
Put the innersole back into the MY FIT thermo liners, step in and roll the MY FIT compression sock over the liner. Step into your skate skate or other sport equipment and firmly close the skates or boots as you usualy do, when you practice your beloved sport.
Go into the optimal position needed for the exercise of your sport – for example in inline skating: knees bend over the toe - and maitain this position until the liner has completely cooled down. We suggest you to sit down during this process, as it will take several minutes.
THE RESULT: the perfect liner, that fits 100% to the anatomy of the foot. Note the distinct narrow shape of the liner, which perfectly wraps around the foot.
  • 100% performance
  • 100% fit
  • 100% comfort
  • 100% fun
if desired, a full custom innersole could be produced through a vacuum process. This can even add superior heel lock and ankle comfort.
The heatmoulding process can be repeated as many times as desired.